The new 12-bay charger is designed to support today s Li-Ion batteries. As agencies deploy more and more phones, the need to charge and maintain larger quantities of batteries rapidly becomes critical. Managing dozens of individual chargers is not practical and no longer necessary.
DON T BLAME THE BATTERY
Before you contact your communications supplier to purchase a replacement battery, consider this: today s high-quality nickel cadmium (Ni-Cd), nickel metal hydride (Ni-MH) and Lithium Ion (Li-Ion) batteries are only as effective as the chargers on which they are placed at the end of the day. Not all chargers are the same and different chemistry batteries need to be charged differently.
There are 2 very important aspects to the charging of a battery that inevitably will determine how long it will last after the charge and how long it will last before it drops below an acceptable level:
AdvanceTec s Li-Ion Specific Chargers
- The method used to charge the battery
- The method used to terminate the charge
Li-Ion batteries are lighter than other energy-equivalent secondary batteries, including both Ni-Cd and Ni-MH. However high charge levels and elevated temperatures from charging will hasten capacity loss. If overheated or overcharged, Li-ion batteries may suffer thermal runaway and cell rupture. In extreme cases this can lead to combustion. Deep discharge may short-circuit the cell, in which case recharging would be unsafe. The AdvanceTec Li-Ion charger makes use of VSCTM (Voltage Specific Control) when charging Li-Ion and Li-Poly chemistry batteries. The discharge pulse has a relaxing effect on the battery, increasing charge acceptance and allowing a charge at a lower temperature. Current is applied until the voltage limit per cell (as recommended by the cell manufacturer) is reached and then the precise voltage per cell limit (±.2%) is applied until the current declines below 3% of rated charge current. If voltage is applied exceeding the recommended voltage, it will cause a rapid and permanent reduction in the number of cycles in the battery.
- A/C input: 110 VAC +5% to -10%, 3A | 220 VAC +5% to -10%, 1.5A
- Current out per bay: 800 mAh
- Output voltage: 4.2V ±0.4%
- Operating battery temp: 0° C to +45° C
- Storage temp:-40° C to +85° C
- Weight: 15 lbs
- Size: 10.40 x 18.11 x 6.57